ahmed ali

when i put for example as files names (1 - 48) the start 1 and end 48 it gives an x on attachment and i only shows from (11 - 21) and rest have x on them :think:
ahmed ali
  • Posts: 31

Erika

How is the file named?
Could it be that you forgot to add the leading 0? (as shown in the gif below)

User avatar
Erika

Erikari
  • Posts: 3082

ahmed ali

it always add images from 10 to 19, they are numeric from 1-20, it always takes the 10 numbers in the middle but rest can't define which is totally name detection issue :think:
You do not have the required permissions to view the files attached to this post.
ahmed ali
  • Posts: 31

Erika

You have to also specify the image path, which in the screenshot is not defined. Does it still happen after doing this?
User avatar
Erika

Erikari
  • Posts: 3082

Nate

Like for region and mesh attachments, Spine uses the attachment name for the Image path is not specified. In your case the attachment name is `FT sparks/spark 2/01. That means the images the sequence attachment will look for will be:
FT sparks/spark 2/0101
FT sparks/spark 2/0102
FT sparks/spark 2/0103
FT sparks/spark 2/0104
etc
I can't see what your image files are named on disk, but I'm guessing you should name your attachment FT sparks/spark 2/ and then it will look for these images:
FT sparks/spark 2/01
FT sparks/spark 2/02
FT sparks/spark 2/03
FT sparks/spark 2/04
etc
User avatar
Nate

Nate
  • Posts: 11930


Return to Bugs